Tag: Thermal Runaway

Quantum Board Power Handling Test

This video covers the results of an experiment I did in order to determine how much power it’d take to destroy an HLG QB288 and QB304 Quantum Board. I was pretty damn surprised!

 

Constant Voltage Thermal Runaway Test #2 – High Current

In my previous test, I ran a couple of Vero 18 COBs at their typical rated current to see if I could get either of them to go into thermal runaway. Over the 4 hours I tested them, each of the COBs ended up pulling an additional ~50mA each than what they started at, but stabilized at this level. Curious to see if I could get one of my COBs to go thermal, I decided to take another stab at this and hit a couple different chips with considerably higher currents than they’d normally be run at.

Here are my results:

Continue reading

Constant Voltage Thermal Runaway Test

After playing with my new HLG-100H-36A constant voltage driver for awhile, I conducted a little experiment this weekend to see if I could get either of my Vero 18 COBs to go into thermal runaway. Thermal runaway can happen in constant voltage systems where the current is allowed to vary, while the voltage is held steady. As the COB LEDs heat up, their properties change, and this causes them to draw more current, thereby heating them up further and drawing even more current. Eventually, the LED can destroy itself due to this cycle of drawing more current and heating.

Quite often, you’ll see recommendations to add a resistor in series with your LED if you’re using a constant voltage driver. I wanted to see if I could get away with skipping these resistors and simply running my COBs hooked up directly to the driver.

Continue reading

© 2017 LED Gardener

Theme by Anders NorenUp ↑