TEKNIK wrote: ↑

Sun Jul 07, 2019 8:54 pm

https://meshtek.com/pages/lighting-overview

Thx,

I was actually thinking of using PiRelay with a pi hat or a regular relay with my rpi as I need to control the fans as well, which are not pwm. Its pretty much the same concept.

Update: I finally got all parts and I'm starting the build. The setup will look like in the picture below. I also built a junction box that will sit on top of the driver. I used Dinkle terminal block and circuit breaker. The power is connected to the 16A 2 pole circuit breaker, which powers the dri...

Project almost completed. Fans are keeping the temps quite low, so I'm thinking of installing a temperature sensor and run them only if temps goes above certain degree. Also installed a 100k ohm potentiometer and dimming works nice. I'm yet to fully automate the system. But I will take one step at a...

Almost done. Only wiring and driver positioning left. Its getting pretty heavy - I need to think of a way to make the frame a bit more sturdy.

Update: I finally got all parts and I'm starting the build. The setup will look like in the picture below. I also built a junction box that will sit on top of the driver. I used Dinkle terminal block and circuit breaker. The power is connected to the 16A 2 pole circuit breaker, which powers the driv...

Hi,

I just got my HLG-600H-54B and it has a wire that I'm not familiar with - RC+/RC-&GRD/+5Vsb - attached is the picture. I'm sure there are experts here that could give me a hand.

Cheers,
Stan

JGG, I love your build. It actually got me inspired to start my 1st build as well. I'm in process of completing (still work in progress) my grow room 8'x10' and I need to cover a 6'x'8' area. Before I saw your thread I ordered 2x QB288 V2 & SLATE 2 TRIPLE kits and was thinking of a good way to buil...

JGG, I love your build. It actually got me inspired to start my 1st build as well. I'm in process of completing (still work in progress) my grow room 8'x10' and I need to cover a 6'x'8' area. Before I saw your thread I ordered 2x QB288 V2 & SLATE 2 TRIPLE kits and was thinking of a good way to build...

Hi, I'm a newbie that got fascinated by the ledgardner youtube tutorials and decided to build my 1st led set of lights using HLG kits. All the information .however is a bit overwhelming for a beginner, so I seek some advice. I end up ordering 2 QB288 V2 & SLATE 2 TRIPLE kits and a GROWLINK HYDROPODS...