I got it all put together and working today, using a hlg-600h-54ab driver. It is in a 5' x 5' used for flowering only. I have read that a lot of people are adding ultraviolet light to their setups would this be an advantage for me? I have limited knowledge on LED lighting and most everything I know ...

Thank you! I had not though about something like that, it is cheaper and more powerful than my Hlg-600H-54ab. But after looking at my bank account I have changed my plans. Haha Last winter I built a DIY HLG 600 Rspec for a 4'x4' tent this year I added a 5'x5' tent and was going to build a DIY HLG Sc...

I just ordered six (HLG QB288 V2 Rspec boards) for a DIY- HLG SCORPION Rspec build and I'm getting ready to order drivers, my question is would it be better to use two Meanwell HLG-480H-54ab drivers or use three Meanwell HLG-320H-54ab drivers? Two 480's are about the same price as three 320's and wi...

I have four (HLG Qb 288 v2 Rspec with heat sinks) wired in parallel to a Meanwell HLG-600H-54AB driver this thing will put out an incredible amount of light. I have it in a 2ft. by 5ft. closet. How many watts should I be running at during veg. and how far away from the plants should I keep them? Whe...

I just went thru my records and Yes I ordered a 100 ohm pot instead of a 100k ohm pot. My BAD!!! I will order a new 100k ohm pot, how many watts should it be rated for? The one I'm looking at is 1/2 watt. Thanks

I'm not sure what I bought at this point with the pot. turned down I get 0.3 ohm's. Turned up I get 104.3 ohm's. is this the wrong pot?

It looks like I bought the wrong potemameter will order 1-10v right now. Thank you very much. YOU GUYS ROCK!

So I finely finished my closet build , 4-[qb 288 v2 Rspec with heat sinks] wired in parallel to a Meanwell HLG-600H-54AB driver. First thing I did was adjust the Vo adj. [built in pot] I set it to 50. vdc ( I believe that is what the boards are rated for) . the driver is plugged into a [kill-a-watt]...

I have my aluminun frame made and all 4 heat sinks mounted. I am ready to wire it up, I have 4- QB288 V2 RSPEC & SLATE 2 SINGLE COMBO from HLG and I have a meanwell HLG-600H-54AB. I am confused about how to wire it to the boards. The meanwell driver has 2 sets of outputs, should I wire it as 2 sets ...

Thank you for the information it was very helpful I went ahead and ordered the HLG-600H-54AB. can't wait for it all to get here, I will post to forum when I get started on my build.
Thanks again