Which driver which strips would b a good place. To start

With the info given here I would recommend looking here

https://m.youtube.com/watch?v=MihcG1iEaNI

As techik has already stated they are two different voltages, so u can’t run them in parallel , Hlg 240 1750 will run all 4 qb132 boards or it will run 3 boards but will draw under 240 watts The driver doesn’t have enough voltage to run 3+1 boards Hlg240 1750 a onboard dimmer Hlg240 1750 b external ...

The only problem I see is u could overload the strips on your first wagos Solution, wire positive from driver to wago then run from that wago to all your other wagos Same for negative See my drawings here ,my original ones have the same fault as yours corrected in last drawing posted https://ledgard...

0.823mm 18awg

https://www.ebay.co.uk/itm/5m-1-1-02mm- ... VcLmMnvcKg

BXEB-L0590U-30E1500-C-C3. 19.1v so hlg 320 20b will be fine,no heatsink is fine or your half mm sheet as long as u run them low enough. 22 strips would run them just under 700ma ,the more u use the less u run them at Hlg320 20 b. (15A). 15A/22 = 681ma (at least 22 strips) Hlg240 20 b 12A. 12A/18 = 6...

My advice would be buy 30mm tape fit to strip trim with a razor blade

Or if u search eBay hard enough I found 25 mm thermal tape ,posted from Belgium

Thanks again
Have attached picture of parallel adjustment

Series or parallel my first option originally was a Pacific light concept design,his advice was series was safer/best but different people will say parallel is

Who to listen to @TEKNIK maybe u could give me your views here

Thank you,your reply has cleared a lot of things in my head I actually think I got diff drivers wiring voltage amps all sorted Haven’t seen your wiring diagram just a picture of your lights thread linked in my original post Have u used Samsung chips before as a comparison,or anyone else I do believe...

I will start by saying thanks to all I spent the last 3 weeks gathering info here, still trying to get it all straight in my head 4x4 am looking at 2x. 2 x4 Was heading for a photo boost build Pacific light concepts, but this looks to be on hold out of stock,good job really who knows how long import...

Here's how I made mine : I used a higher volt driver so I could add the red diodes. To cut a long story short ,was about to buy Samsung strips (SL-B8V3N80LAWW)wiring in series then adding red later on diff driver (rapiled solderless),after reading this your build is perfect for what I want ,much ch...