Ok but is there a way to know what numbers the light should be putting out at a certain distance ignoring numbers I got from my lux meter?

Cheers

You know what im actually not sure it does have a flicker lol, think it might just be my eyes.

Thanks Peter, do u think think a flicker could be caused by damaged strips, a couple got stuck in the wrong place while placing them and I had to rip them back off, which I was convinced would have damaged them.

Any idea on my previous question about umol output, cheers.

Just for you 'tittyexpert

Oh and I seem to be getting a small flicker, although it's barely noticeable.

Is this normal?

Thanks

Built the light, it's amazing! Just wanted to thank you for all the help! Is there a way to know how many umols it should put out, I have a lux meter and used a conversion factor for 4000k high cri leds, but can't be sure how accurate the meter is. I'm getting 26k lux at 4 1/2" which the calculator ...

So i recieved all the bits, except I forgot connection blocks.

Only just looked properly at the wiring diagram,
the title 2 series / 5 parallel through me off.

Do i just follow that diagram ignoring the extra six strips ?

Cool idea, I might struggle to find a 2ft pan for cheaper than the alu sheets tho. Like the idea of screwing directly to the alu, do you need special screws or washers for these strips ? My concern is laying the strips out for the best coverage, once they screwed/stuck down it be annoying to hav to ...

Actually I'll get the one you linked, noticed a nice knob for it in the "you may also be interested im" section. For heatsink I'm going to get an aluminium sheet, seems to more cost effective and will be easier to mount it all, any ideas how thick Alu sheet needs to be to be rigid? Plus I'll need th...

Oh I missed the dimmer in the diagram.

I also have lots of cables/wires so sure I'll find something suitable.

So as long as a Potentiometer says 100k ohm it's good?

Think I'd like to find one in a nice housing, that metal one scares me

Thanks