Ok, found gromau5 vid 5 of 6 indicates using the Wago connectors to join multiple drivers to one wall plug.

I should mention I have an assortment of Wagos I could use.

Hi all I have a question on joining power cords going to the wall of my qb132 light. I made a frame with two QB132's and a Meanwell LPF-60-36 power supply for each board. To run power to the wall from the drivers I modified two 4' 16 gauge extension cords, cutting off the female ends but kept the wa...

Thanks for letting me know. I raised the drivers up off the boards and they are same temps heat isn't coming off the boards.. My first grow and probably stressing about every little thing as you mentioned.

Thanks for the reply. I tried to attach a pic but can't get it to work. Not sure if you need a minimum post count for that? I can raise the drivers, (I built a double QB132 board with two drivers), off the board. Thanks for the idea to check out with washers. I'm going to try that. I'm also wonderin...

I'll try to post pic of QB..

Would this different driver run significantly cooler? Looking at this one and also has a ground wire.

https://ca.mouser.com/datasheet/2/260/r ... 109604.pdf

I have no experience with the power supplies although I've learned a lot on here. Not sure if/how hot they are supposed to get with the QB132(heard they run cool) and if I hooked things up wrong? Here are the driver specs: http://download.siliconexpert.com/pdfs/2016/12/18/12/47/48/587/mwe_/manual/37...

Definitely go with the Wago connectors and LLT-L20 3 pin for the wall side. Makes life a whole lot easier!

Initially purchased a HLG 185h c1400 to power 4 QB132's but am thinking to run a single board instead of the four. Hooked up a Meanwell LPF-60-36 as recommended by HLG site to one board but now getting a lot of heat from the power supply which is mounted on the board. Did I misread the HLG recommend...