So they're on their heat sinks and all wired up. Used em turned down a bit for vegging (one of my plants decided to damp off or some fucking nonsense after transplant, not sure what was up with that), threw a net in and trained the remaining 3 to more or less fill the void. Turned the driver up and ...

Looks awesome!

Will it matter if I use the A or B type driver? It seems digikey shipped me an A in my box of B.. I do not think it matters unless you wanted to dim the driver significantly. With the A type you can set the voltage +/-10% of max with the built in pots. You can then adjust the io pot and turn it dow...

Why not just have the drivers run remote....a few bucks in wire and problem solved? Do the 480s have dual leads to the boards like the 600s? It would still allow 4 separate units, just any dimming would be limited to pairs of units, rather than individual as described.

If I am smoking crack and have this all wrong, please tell me! Lmao! your pretty much dead on my friend 😁 I'm still learning these v2 numbers 😁 Awesome, I appreciate the help/reassurance! Just want to make sure I wouldn't have been better off torching a few c notes instead of wiring all this up. To...

And feel free to jack the thread, the more info the better. So I just jumped on a hlg-600h-48a. The plan is to run the 288v2s somewhere around 2500 mA (~49.6v, the 48A maxes around 50.4) keeping the w/board around 120. So each output from the driver will be running 2 boards in parallel, for a total ...

So I must have ordered the wrong thing, the 4 288v2 and 4 single slate 2s showed up yesterday. The slate 2s are rated for 100-150w for singles, so I believe I'm good running the 600? Thanks for the help, I dont want to fry a couple hundred bucks worth of leds...

So I shouldn't run 4x288s on a HLG-600h-48a?

Thanks for the reply! I just scoped out LGs 4 part thing about drivers. Probably should have gone there first. Please correct me if I'm wrong: V2s run 2.8A @ <50w. TypeA CV drivers have +/- of ~10% If I'm running 4@2.8A I'm over the 480h rating. The 600h-48A is rated for 12.5A, allowing me to run al...

Hey folks, thanks in advance for any and all help. I've been searching around and cant decide between parallel/series as it doesn't look to matter much? As mentioned, I have 4 qb288 v2s @ 3000k on the way with 2 double slate 2 heat sinks. I'm leaning towards 2 drivers and just mount on the heat sink...