yes that is the one I have. but regardless of the controller.... I feel like the 5-15p and 6-15p are only different so that people don't accidentally plug a 120v into a 240v or a 240v into a 120v. but if my controller is wired for 240v, and my spydrx+ / gavita / meanwell drivers all accept 120-240v ...

Ok so I have an autopilot 8-light controller that is wired 240v. This controller can be wired in either 120v or 240v. and it has female plugs for your lights that will accept either the 5-15p (standard 120v) male, or the 6-15p (standard 240v) male. I puchased a spydrx+ from my local shop and they ac...

I contacted rapidled about their cased potentiometer. I asked if they had a 33k ohm one or could do the 30k ohm with resistor wired in. This was their response: resistance is variable on the cased pot so one cased pot will work for three drivers. Just wanted to double check if this is ok because as ...

ok well im trying my best to understand this all but I heres my situation: I have 25k ohm pots because I intended to wire 4 drivers together but because I changed my setup a little bit, I only need 3 drivers to wire together, hence now needing different pots. 1- What would the result be of using the...

now I am confused. what is a b50k/ b503 pot?

could someone link the appropriate pot?

is this one good?

hey guys, originally I was going to use 4 drivers on my fixture (hlg-185h-c1050b), but I've switched to 3 (hlg-320h-c1400B) to wire up 12 QB288V2's So, four qb288v2's on each hlg-320h-c1400b I had already ordered the 25k ohm potentiometers because I was planning on wiring the 4 hlg185s together to o...

could someone explain to me the differences between these 288pc lm301b vs hlg's qb v2 with 288pc lm301b?


like as in why do these boards say 2200ma is 120w when hlg's is 2400ma @ 118.8w?


and also atrium says 54vf, but HLG lists VDC. sorry I only have a loose grasp of all this stuff trying to learn

what about four qb288v2's on an hlg-320h-c1400b? that's 83% of the voltage, and its a driver that will dim to 0 which makes using the trolmaster controller easier to wire up since it is capable of dimming to 0.
anything wrong with this config?

ok so I plan to run 12 qb288v2's over a tray for a theoretical maximum 800w. on a phone call with HLG he recommended to use 4 hlg-185h-c1050b drivers and run 3 boards on each in series. thinking about it (after purchasing the drivers) i was confused because I thought that it would only run the board...