Re: potentiometer question
Posted: Sun Jul 29, 2018 9:03 pm
I contacted rapidled about their cased potentiometer. I asked if they had a 33k ohm one or could do the 30k ohm with resistor wired in. This was their response:
resistance is variable on the cased pot so one cased pot will work for three drivers.
Just wanted to double check if this is ok because as far as i knew i needed a linear taper pot of a specific resistance
resistance is variable on the cased pot so one cased pot will work for three drivers.
Just wanted to double check if this is ok because as far as i knew i needed a linear taper pot of a specific resistance