Page 2 of 2

Re: Ready to Wire !

Posted: Thu May 24, 2018 5:14 pm
by Sativant
Quantums are fantastic light sources too ! If you spread the quantums out, you can get really even coverage with them also.

Re: Ready to Wire !

Posted: Fri May 25, 2018 3:32 pm
by unkle_psycho
Nice Build!

Re: Ready to Wire !

Posted: Fri May 25, 2018 7:20 pm
by unkle_psycho
Do you have a dimmer? You could probably lower the light quite a bit, but probably not without dimming it :D

Re: Ready to Wire !

Posted: Sat May 26, 2018 1:50 am
by Sativant
I do have a dimmer. I have it set to run at about 300 Watts. It’s about 22” above the canopy. That picture makes it look high. I’ll turn it up later, perhaps, depending on the temperature. It’s perfect right now with the vent fan turned down.

I love the strips and being able to have a light that is just six inches smaller than the closet it’s in. Without the driver on it, it’s very light and low profile. Thanks to LEDG.

Re: Ready to Wire !

Posted: Sat May 26, 2018 5:24 am
by alienfarts687
I, too, decided to mount the driver remotely, to maximise vertical space and reduce heat. Nice build!

Re: Ready to Wire !

Posted: Sun May 27, 2018 12:34 am
by Complex
Nice job man.