Re: LED design for 5 x 5 tent
Posted: Fri Aug 11, 2017 3:50 am
of course I loved it!!!! it's good to know.... ( and knowing is half the battle!! G.I. JOE!!)
A friendly LED grow light community.
https://ledgardener.com/forum/
There is/was a HLG-600 too. Not in stock for the moment, don't know if they will come on stock again.Ted wrote: ↑Thu Aug 10, 2017 2:27 pmDo you mean the HLG 550? Here is a ppfd measurement video in a 4x4 and it was low in the corners.Tune wrote: ↑Thu Aug 10, 2017 1:49 pmHi again,
I saw the HLG-600 but had some thoughts about it.
The HLG-600 is recommended for a flowering footprint of 5 X 5.
This is 4 QB 288 on a slate 5 which is 740mm X 390mm (that's about 2,7 ft x 1,3 ft).
Correct me if i get the conversion wrong.
Is this light getting enough PPFD in the corners of a 5 X 5 tent???
https://www.youtube.com/watch?v=ITlJGQ576-Y&sns=em
A HLG 550 with 4 COBs on the corners for the additional coverage would be badass.
I just built an HLG-550. I have 2 3590s and 2 Vero 29 v7s that I want to add to the corners. I'm trying to figure out how to build the frame and mount it to the heatsink.Ted wrote: ↑Thu Aug 10, 2017 2:27 pmDo you mean the HLG 550? Here is a ppfd measurement video in a 4x4 and it was low in the corners.Tune wrote: ↑Thu Aug 10, 2017 1:49 pmHi again,
I saw the HLG-600 but had some thoughts about it.
The HLG-600 is recommended for a flowering footprint of 5 X 5.
This is 4 QB 288 on a slate 5 which is 740mm X 390mm (that's about 2,7 ft x 1,3 ft).
Correct me if i get the conversion wrong.
Is this light getting enough PPFD in the corners of a 5 X 5 tent???
https://www.youtube.com/watch?v=ITlJGQ576-Y&sns=em
A HLG 550 with 4 COBs on the corners for the additional coverage would be badass.