Hello everyone! I’m fat and new to the wonderful world of DIY led’s,
I sure do hope that the ELG 240 c1750 can power 4 QB132 from HLG. I just clicked home both things and realized that I I screwed up the second I did it. Go impulse control eh?
Any who, is there any chance that this will even power up?
Can I perhaps make it work by removing some diodes?
Does an open circuit voltage of 144 make it possible to run them, even though that the constant current region only goes to 137?
These boards would require 34.8 x 4 (139.2) min fv at 1750 mA according to hlg,
...
Really thankful for any answer in the matter. Kind regards
