Can't power on my HLG 480 mockup
Posted: Sun Sep 16, 2018 2:30 am
Hey, guys. I could use some help!
Been over a day and I cant turn on my build
I tried changing connectors, i tried cutting the wire and soldering, and nothing seems to get this HLG 480 C2100B on. I have 4 288.2s hooked up and the driver refuses to power on.
I had to cut the power cord up to seperate it into 3 parts, based on the thick plastic coating i had to tear off it was impossible not to get a couple threads with it. So each wire may be missing a couple threads. Not sure if this matters. Figured out the negative wire based on some writing on the cord. All wires were black except the green.
Is this a problem with my cord? It's 15 amps and 18 gauge, 120volts but universal. What am I doing wrong here?
Been over a day and I cant turn on my build
I tried changing connectors, i tried cutting the wire and soldering, and nothing seems to get this HLG 480 C2100B on. I have 4 288.2s hooked up and the driver refuses to power on.
I had to cut the power cord up to seperate it into 3 parts, based on the thick plastic coating i had to tear off it was impossible not to get a couple threads with it. So each wire may be missing a couple threads. Not sure if this matters. Figured out the negative wire based on some writing on the cord. All wires were black except the green.
Is this a problem with my cord? It's 15 amps and 18 gauge, 120volts but universal. What am I doing wrong here?