Troubleshooting Help: Light Output Suddenly Reduced
Posted: Sat Apr 20, 2019 4:22 pm
Hello everyone!
I am in need of a little advice regarding troubleshooting my DIY light (build thread: http://ledgardener.com/forum/viewtopic.php?f=11&t=467). Just recently my HLG-150H-20A appears to only be putting out 18.5 V to each strip (I tested all but two at various places in the light). There have been no changes to the setup, all of my connections are secure and checked. I am just not sure what is causing it.
Could it be the potentiometer and can I test that with it hooked up? (Assuming just with the voltmeter across the unused terminal and the center to measure the resistance?) I am a noob when it comes to troubleshooting these types of electrical problems so any help would be greatly appreciated. Thanks!
I am in need of a little advice regarding troubleshooting my DIY light (build thread: http://ledgardener.com/forum/viewtopic.php?f=11&t=467). Just recently my HLG-150H-20A appears to only be putting out 18.5 V to each strip (I tested all but two at various places in the light). There have been no changes to the setup, all of my connections are secure and checked. I am just not sure what is causing it.
Could it be the potentiometer and can I test that with it hooked up? (Assuming just with the voltmeter across the unused terminal and the center to measure the resistance?) I am a noob when it comes to troubleshooting these types of electrical problems so any help would be greatly appreciated. Thanks!