Page 1 of 1
New build want to add some red
Posted: Thu May 02, 2019 7:54 pm
by Okiegrown918
I just built a new light 4xqb288 v1 3000k powered by a hlg600h-54b and I want to add some red supplemental lighting any suggestions? Do I need another driver? Light is in a 4x4 tent that will be used for flowering.
Re: New build want to add some red
Posted: Thu May 02, 2019 11:41 pm
by Jolly Green Giant
welcome to the forum first off..
https://horticulturelightinggroup.com/c ... cts/hlg-35
https://www.rapidled.com/emerson-effect-booster-board/
these are two easy to do solutions... both can run without a heat sink, but you would want to mount them to something for more rigidity / support.. both also can come with the wall wart type driver, so it's just plug and play.
again welcome
