LEDgardener

Hi,
I'm running small fixture of eb gen2 280mm, thanks to the help of this forum
I've got a small space and I'm happy with the results.
9 eb gen2 28mm
HLG-60H-C350A

I've got room (and power) to one more strip, I've been reading here about red 660nm.
Should I add one 660nm strip to my fixture, or one more eb gen2 280mm?
Is there a 660nm strip that can fit to my fixture (on the same driver)?

Thanks

Hey...

maby one of those:
https://horticulturelightinggroup.com/c ... ntum-board

Or maby better this 660nm option but u need a different driver...
https://horticulturelightinggroup.com/c ... 2772940827

But for such small setup, ill prefer to add one more EB2 strip...

The linked red strips are to long for OP’s fixture. Your best bet is to buy a couple of mono’s from rapid LED if you are in the states. I don’t personally know of any ~1’ red strips.

1ft in a wide range of variable reds, using the latest Cree XPG-3 G bin, the >4umol bin
https://www.cutter.com.au/product/cutte ... xp-custom/
Available in red, deep red, far red, IR or mix of any
Cheers
Mark

Thanks