Opening a Meanwell HLG Series Driver
Posted: Fri Nov 16, 2018 11:28 pm
Hey all,
Apologies if this has been asked before....
I've been thinking about replacing the potentiometers in my HLG-185H-24A drivers with digital ones for automation. However, I tried to remove the upper shell a few weeks back after removing the screws (though not the machined punched? ones underneath), and although applying a reasonable amount of pressure, it was not enough to cause any movement.
Has anyone repaired/modified a H series meanwell driver (assuming they are all similar in design here) and know the best way to go about this?
As the drivers are rated IP65, I really don't want to damage any internal materials...seems a waste of warranty if modification is not possible too.
Thanks very much in advance!
Apologies if this has been asked before....
I've been thinking about replacing the potentiometers in my HLG-185H-24A drivers with digital ones for automation. However, I tried to remove the upper shell a few weeks back after removing the screws (though not the machined punched? ones underneath), and although applying a reasonable amount of pressure, it was not enough to cause any movement.
Has anyone repaired/modified a H series meanwell driver (assuming they are all similar in design here) and know the best way to go about this?
As the drivers are rated IP65, I really don't want to damage any internal materials...seems a waste of warranty if modification is not possible too.
Thanks very much in advance!