How spaced apart should strips be?

[Calenk]

In a 2x4 tent how spaced apart would you place two 4 footers? would it be best to have them evenly spaced with the walls and each other?

[unkle_psycho]

What type of canopy are you building? Are the walls mylar?

[Calenk]

What type of canopy are you building? Are the walls mylar?

it's for my veg tent. 2x4 mylar.

[unkle_psycho]

Perhaps something like 25cm? it would leave 15cm for the sides. I think that would avoid too much of a hot-spot in the middle.

I don't have a par meter, but I could look at placing for even coverage with a lux meter. About how high above the plants would you have the light?

[Calenk]

I don't have a par meter, but I could look at placing for even coverage with a lux meter. About how high above the plants would you have the light?

I'm not sure probably like 18 inches.

[Hydrofood]

I found this yesterday on RIU researching this same topic.

1. Start from the middle
2. Decrease the space between the strips by 30% of the previous space in both directions
3. Make sure the width you start with will yield nearly full coverage of the expected canopy size.

The author provided LUX of before (linear spacing equally), and after (logarithmiclly) and the light was far more uniform after spacing logarithmically.
I will try and find the thread I read.

[Calenk]

I found this yesterday on RIU researching this same topic.

1. Start from the middle
2. Decrease the space between the strips by 30% of the previous space in both directions
3. Make sure the width you start with will yield nearly full coverage of the expected canopy size.

The author provided LUX of before (linear spacing equally), and after (logarithmiclly) and the light was far more uniform after spacing logarithmically.
I will try and find the thread I read.

yes please do I'd love to read it.