Page 2 of 2
Re: Need help for Bridgelux Gen. 2 BXEB-L0560Z 1′ LED Strip Build – 1’x1′
Posted: Tue Feb 20, 2018 4:54 pm
by Jolly Green Giant
Karlsef wrote: ↑Tue Feb 20, 2018 2:12 pm
Very nice concept; I am looking to do something similar however in Canada they don't appear to have any 2nd Gen 1 footers in stock anywhere. Most likely I will use the 2 footers and if they don't fit inside my 2x2x4 tent I will have to reconsider my space.
yep the 1 footers go quick.( 5000k only ones in stock atm
) the "two footers" are 560mm=22" if you only add a 1/2" heat sink further on each side(23" total) and use angle 3/4 x 3/4 as frame.... it should just squeeze in the tent.. my 5x5 is a hair bigger than 60"... most are slight bigger.. but there is always a few that are dead on or slightly smaller.
Re: Need help for Bridgelux Gen. 2 BXEB-L0560Z 1′ LED Strip Build – 1’x1′
Posted: Tue Feb 20, 2018 7:02 pm
by violenzo
"again your math is spot on.... but I think your looking at gen 1 strip data sheets
( the 22.1v and 50C giving it away..... gen two 19.5v and 25C...I looked at the same data sheet a few times before figuring which was which)"
ahahaahhaha too much calculation and searches on the net..ok..everything is allright..i'm gonna recalculate what i need..now i have understand 2/3 of what i need to know..tomorrow i'll go to an electro shop that i saw yesterday for the little parts and i'll spit out my doubt..thanks again..
Re: Need help for Bridgelux Gen. 2 BXEB-L0560Z 1′ LED Strip Build – 1’x1′
Posted: Wed Feb 21, 2018 7:30 pm
by LEDG
Yeah I like the HLG-60H-20 for this build.