Page 1 of 1
bridgelux eb gen2 series wiring
Posted: Thu Oct 18, 2018 8:45 am
by rubberduck
eb gen2 strips in series, 200v too much for the series of strips?
whats the voltage rating of the board and wire connector?
thank you
Re: bridgelux eb gen2 series wiring constant current
Posted: Thu Oct 18, 2018 1:29 pm
by Shimbob
Take a look at the specs here:
https://www.bridgelux.com/sites/default ... ev%20A.pdf
Specifically look at figure 5, which tells you what voltage the strips need at what current. At 700mA, the strips run at 39volts. 5 strips in series will require (5x39=)195V. 210 is just fine, the strips will be happy photon canons.
Usually the wire connectors on the strips are rated for a max of 300V. The boards themselves have no maximum voltage since its excessive current that will make them pop. Excessive voltage passes through them harmlessly.
Re: bridgelux eb gen2 series wiring constant current
Posted: Thu Oct 18, 2018 5:11 pm
by rubberduck
Shimbob wrote: ↑Thu Oct 18, 2018 1:29 pm
Usually the wire connectors on the strips are rated for a max of 300V. The boards themselves have no maximum voltage since its excessive current that will make them pop. Excessive voltage passes through them harmlessly.
thank you
Re: bridgelux eb gen2 series wiring constant current
Posted: Thu Oct 18, 2018 5:24 pm
by Shimbob
Strips in 5S2P, looks good, will put out 273watts.
Re: bridgelux eb gen2 series wiring
Posted: Thu Feb 20, 2020 9:43 pm
by Shimbob
I was wrong, max voltage on ebg2 is 60V, did you build it?