Help with first time 301b strip build
Posted: Mon Jun 01, 2020 3:15 am
I bought some strips / sinks / driver from eBay. Actually talked to the guy on the phone, helped walk me thru what I needed. Overall good experience.
Here's the lowdown:
(4) 4x Sun Board 96 LED LM301b 6500k
(1) HLG 150H-48A Driver
I built a neat little frame (or so I thought) to accommodate a 2x4 shelf setup. Was using this video as a bit of a guide on how to wire it up.
Then checked out the 2x2 build with 4 strips on the strips build page here. Seemed this was the way to go: I can wire 2 of the boards in series and it works fine:
When I wire all 4 in series, I get nothing: All 4 work in parallel, but it's a bit messier wiring. Am I missing something? Is there some limitation with the driver that I'm unaware of? This is the driver: This is what I'm hoping to do:
Here's the lowdown:
(4) 4x Sun Board 96 LED LM301b 6500k
(1) HLG 150H-48A Driver
I built a neat little frame (or so I thought) to accommodate a 2x4 shelf setup. Was using this video as a bit of a guide on how to wire it up.
Then checked out the 2x2 build with 4 strips on the strips build page here. Seemed this was the way to go: I can wire 2 of the boards in series and it works fine:
When I wire all 4 in series, I get nothing: All 4 work in parallel, but it's a bit messier wiring. Am I missing something? Is there some limitation with the driver that I'm unaware of? This is the driver: This is what I'm hoping to do: