PLC Heatsink help/suggestions
Posted: Wed Jun 17, 2020 10:56 pm
Hey gang, had a question about a build I'm starting with the Photoboost strips. I'm following GreenGene's 4x4 660w build with 8 bars, 16 strips. In his newest build design, he uses a 1"x2" aluminum extrusion as a frame/spine, and 1"x1" extrusions as heatsinks for the boards. I want to go with a 1"x3" extrusion as the frame to mount the two HLG 320w drivers directly on it, while maybe using the 1"x0.5" profile extrusions as heatsinks to keep the weight to a minimum.
Basically, my question is if the .5" profile extrusions are enough to cool the boards without overheating.
Thanks!
Basically, my question is if the .5" profile extrusions are enough to cool the boards without overheating.
Thanks!