Page 1 of 1
EB Gen 2 2ft help needed
Posted: Wed Sep 09, 2020 9:02 am
by Shamz
Hi All,
i have 20 x 2ft 3500k strips and a HLG-320H-42A driver. How would i wire this to get close to the maximum wattage?
Thanks in advance
Re: EB Gen 2 2ft help needed
Posted: Wed Sep 09, 2020 1:33 pm
by PeteR_1
Shamz wrote: ↑Wed Sep 09, 2020 9:02 am
Hi All,
i have 20 x 2ft 3500k strips and a HLG-320H-42A driver. How would i wire this to get close to the maximum wattage?
Thanks in advance
2 Series / 10 Parallel Circuit will get you the full Wattage (320+ Watts) from the HLG-320H-42A LED Driver (@
21 - 42 Vdc).
Two (2) Bridgelux 560 mm Gen 2 wired in Series are
39 Vdc (19.5 Vdc each). Good Luck.
- Typical Series / Parallel Wiring.
Bridgelux Gen2 Datasheets...
https://www.bridgelux.com/sites/default ... ev%20A.pdf
HLG-320H-42A Datasheet...
https://www.meanwell.com/Upload/PDF/HLG ... H-SPEC.PDF