A friendly LED grow light community.
https://ledgardener.com/forum/
Probably Not safe for LED Driver, if the Strip is 20 Vf...
Thanks, but the reason I'm asking is because that I have this driver lying around.PeteR_1 wrote: ↑Sun Dec 13, 2020 4:11 pmProbably Not safe for LED Driver, if the Strip is 20 Vf...
But, you could run a single strip on a Dimmed HLG-60H-24AB (or -B) Driver, which has a CC region of 14.4 - 24 Vdc and can be dimmed down to ~ 10% (10K Ohm Resistor or 100K Ohm Pot @ 10K Ohm).
HLG-60H-24 LED Driver Datasheets... https://www.meanwell.com/webapp/product ... od=HLG-60H
You're welcome.eladmitz wrote: ↑Sun Dec 13, 2020 4:32 pmThanks, but the reason I'm asking is because that I have this driver lying around.
I'm trying to find meanwell driver that can run a single 20v strip with the option to adjust current between 350-700~ with internal io dimmer, but I cant find one.
The only one that I can find is xlg-25-a, but the constant current region of this driver is : 22 - 54v.
Does anyone have a suggestion for this kind of driver?
Thank u very much for your time.PeteR_1 wrote: ↑Sun Dec 13, 2020 5:09 pmYou're welcome.
1. You could run a single strip on a Dimmed HLG-40H-24B Driver (-24AB would be better), which has a CC region of 14.4 - 24 Vdc and can be dimmed down to ~ 15% - 35% (100K Ohm External Pot @ 15K - 35K Ohm)
HLG-40H-24B LED Driver @ Digikey... https://www.digikey.com/en/products/det ... f3e7cdd640
HLG-40H-24B LED Driver Data sheet... HLG-40H-24B LED Driver Datasheets... https://www.meanwell.com/Upload/PDF/HLG ... H-SPEC.PDF
2. Or a TRP 40 Watt LED Driver with a CC region of 7 - 22 Vdc and an external 100K Potentiometer...
TRP 40 Watt LED Driver @ Digikey... https://www.digikey.com/en/products/det ... -D/6574712
TRP LED40W-022-C1820-D Driver Datasheets... https://hubbellcdn.com/specsheet/LED-40W.pdf
3. Or Meanwell LED Drivers at 350 mA or 700mA @ 20 Vdc...
Meanwell LED Driver CC region 12 - 48 Vdc, 350mA @ 20Vdc = 7 Watts...https://www.digikey.com/en/products/det ... 50/7702569
Meanwell LED Driver CC region 9 - 24 Vdc, 700mA @ 20Vdc = 14 Watts... https://www.digikey.com/en/products/det ... 00/7702570
Good luck.
You're welcome.eladmitz wrote: ↑Sun Dec 13, 2020 5:56 pmThank u very much for your time.
As I can see, no internal dimmer option..
So if we go external, what do u think on -
LPF-16D-24 :
https://www.meanwell-web.com/content/fi ... D-spec.pdf
Thanks again
Thanks!PeteR_1 wrote: ↑Sun Dec 13, 2020 6:16 pmYou're welcome.
That should work OK...
Almost any Dimmable Driver that has an adequate Output Voltage Range and Adequate Wattage output can work in your application...
Just successfully tested a single (1) Bridgelux BXEB-L0560Z LED Strip with Dimmed 75 Watt , 8 - 25 Vdc LED Driver @ 140 mA (min) to 800 mA with a 100K Potentiometer.
Simply need an LED Drive that can output 7 - 14 Watts @ ~ 20 Vdc (350 - 700 mA @ ~ 20 Vdc)...
Bridgelux 560mm LED Strip... https://www.digikey.com/en/products/det ... B3/7907663
75 Watt TRP Driver... https://www.digikey.com/product-detail/ ... C3000-D-ND