Efficient Driver for 4x QB

[Jolly Green Giant]

Only hope she doesn't get too hot w/o heatsinks. I don't even have the potentiometer setup yet, and I assume it will get hotter once installed and running stronger. I have a fan blowing over the top seems to help quite a bit. I let it go about 30 minutes w/o fan and it got really warm.

Also, may have went overboard with the length of the screws, but they're attached. Appreciate all the help from the forum.

nice! I also agree.. fans would hurt.. another thing ya could do is mount the driver remotely. the heat from that isn't helping I know how hot mine runs lol.

also agree with LG about the grommets.. https://www.amazon.com/gp/aw/d/B06XFDX8 ... ref=plSrch I think that's the kit I bought for the holes on my slate heat sinks.

[ronaldmosely]

So I went ahead and got the 600H 54A my question is what do we so with the RC wires? And what are they for? I'm assuming remote controlability.

[Jolly Green Giant]

I'm assuming "remote on off control" also... I looked at the data sheet since I haven't seen one in person... noticed that RC part that's not on my 480

[ronaldmosely]

Here it is hooked up and ready to rock.

[bvolt]

I just picked up a 600H-54B... what gives with the 2 sets of DC leads?