LEDgardener

Hi guys, I am going to be building a qb copying the HLG 100 V2 4000k. Will be using LM301B LED cut tape so will have to pull out the soldering iron, can't get the strips near me

My first question is what driver would you recommend? I can't seem to find any information around the driver. Also I don't need dimming.

My second question, can I run a fan off the same driver?

So it looks like it is the OWA-90U-36-P1M mean well driver however digikey in South Africa only sells a pack of 16.

They do sell the OWA-90U-36 individually, what does the

P1M

stand for?

Lastly, I think the driver was used for the V1 boards which had LM561C LEDs, however I will be using the LM301B LEDs - will the old driver be ok for the new diodes?

See the specs here https://meanwellusa.com/productPdf.aspx?i=290