LEDgardener

Hey fellas,

I recently got the 2*QB288 LM516C 260w kit from kingbrite on Alibaba. It contained a MW HLG-240H-48B Driver + Potentiometer. Now I am newbie to LED builds and have no electrical knowledge. I guess the 2 boards come with parallel wiring . I don't know how to connect the output voltage wires to the QB . There are total 8 (4 positive + 4 negative ) points on the board. All positives are at the top and negatives at the bottom of the board. How should I connect them ? I don't want to end up with a fire .

Thanks

Welcome to the forums. Here is a picture that demonstrates how to wire your two boards in parrallel. You will be using two instead of 4 but the same concept applies.

https://i2.wp.com/ledgardener.com/wp-co ... rallel.png