2x QB324 build, up and running!
Posted: Tue Mar 05, 2019 3:26 am
Hello to all,
Just concluded my build of 2x HLG QB324 , with slate 2 heat sink, 90 degree custom optics, mounted on a simple aluminium frame I have built.
I have wired in parallel with the HLG-320H-54A driver, using a 3 slots wago directly from the driver, insted os using the boards conector to pass thru, hope thats fine. I regret a bit not getting the B series for remote dimming.
The heat sinks are getting very hot if I run at max(both knobs), not dimmed in any way, tent gets at 28c in 1-2 hours, but the heatsink is hot to the touch, cant keep my hands on, the frame is ok, you think is best for me to dial down a bit the voltage to get less heat? My only consern is safety and melting the boards...
Now I just have to get a hang on the hight distance for good results.
For the rest I’m very exited to put this to use and super satisfied,
Thanks a lot for all the infos! All the best! Happy growing!
Just concluded my build of 2x HLG QB324 , with slate 2 heat sink, 90 degree custom optics, mounted on a simple aluminium frame I have built.
I have wired in parallel with the HLG-320H-54A driver, using a 3 slots wago directly from the driver, insted os using the boards conector to pass thru, hope thats fine. I regret a bit not getting the B series for remote dimming.
The heat sinks are getting very hot if I run at max(both knobs), not dimmed in any way, tent gets at 28c in 1-2 hours, but the heatsink is hot to the touch, cant keep my hands on, the frame is ok, you think is best for me to dial down a bit the voltage to get less heat? My only consern is safety and melting the boards...
Now I just have to get a hang on the hight distance for good results.
For the rest I’m very exited to put this to use and super satisfied,
Thanks a lot for all the infos! All the best! Happy growing!