LEDgardener

Hi. Im new to this LED world and I need some help.
Im getting my old HPS light out due to heat and I got myself two samsung quantum boards.
I got the mean well HGL-240H-C150B driver for those two boards.
As far as I understand, this is a cc mode driver and that means I have to connect the boards in series, right?
On each board there is 4 connectors, two positive and two negative. How do I connect the two boards together? And what wire goes to the driver?

I am grateful for any help I can get

Can you link to the exact model of boards you have?

Depending on the model, 1050mA may be a bit on the low side for powering these things.

I bought them off a friend so I dont have any link. But it`s Samsung 3500k LM301B + Cree 660nm 730nm + LG UV 390nm

Not sure what those are but if they're anything like normal QB's then you'd wire them in series. I can't guarantee it's right without anymore details about the boards but here's how series would work:

Driver positive to positive of board number 1, driver negative to negative of board number 2, then connect negative of board 1 to positive of board 2.

Thanx for all the help I`ll post some pictures when it`s up and running

Cheers!