I have a INVENTRONICS EUD-600S280DT driver powering 4 qb288rspec boards. I've become interested in the vdc output off the driver, it tests in series at 2.455 amps, the specs show it should be 2.800amps at full blast. The power draw from the wall is 575w after 1 hour warm up period, it shows closer to 595w @ cold start, then drops down to around 575w over an hour or so. The questions are should I bump the driver up to 2800amps using PRG-MUL2 AOC driver controller? or have I missed something ie.. the behavior is normal for this driver.
Geoff.
