you're right about the pins ,
https://files.atlas-scientific.com/Wi-F ... -guide.pdf
page 4
your tasmota is the new version 11.1.0 ?
Setting up Atlas Scientific sensors in ESPHome (aquaponics kit)
I think it's technically 11.1.0.1 (the dev version)
Another beginner tip I discovered: The "Configure Template" tab (that I was able to change all at once via the board code from Tasmota in "Configure Other - Template") sets the options for "Configure Module". So if you set your SCL and SDA pins in the "Configure Template" they won't show up in "Configure Module". Only pins marked as User will show up in Configure Module if you wanted to clean your available options.
Another beginner tip I discovered: The "Configure Template" tab (that I was able to change all at once via the board code from Tasmota in "Configure Other - Template") sets the options for "Configure Module". So if you set your SCL and SDA pins in the "Configure Template" they won't show up in "Configure Module". Only pins marked as User will show up in Configure Module if you wanted to clean your available options.