Hey all,
Apologies if this has been asked before....
I've been thinking about replacing the potentiometers in my HLG-185H-24A drivers with digital ones for automation. However, I tried to remove the upper shell a few weeks back after removing the screws (though not the machined punched? ones underneath), and although applying a reasonable amount of pressure, it was not enough to cause any movement.
Has anyone repaired/modified a H series meanwell driver (assuming they are all similar in design here) and know the best way to go about this?
As the drivers are rated IP65, I really don't want to damage any internal materials...seems a waste of warranty if modification is not possible too.
Thanks very much in advance!
Opening a Meanwell HLG Series Driver
I ruined one of my drivers trying to get into it. There is thick black rubber on the inside and it's really nasty to try and separate the shell. I wasn't able to even get it, despite practically destroying the case.
Want to Support the Site?
Use this Amazon referral link and any purchase you make within 24 hrs will earn LEDgardener a commission at no cost to you!
Use this Amazon referral link and any purchase you make within 24 hrs will earn LEDgardener a commission at no cost to you!