I now have two which I want to wire in parallel.
So these PCB's are so damn efficient that I am struggling to identify a suitable DC driver.
Here are the electro-optical data from their data sheet:
A note at the bottom recommends a constant current source:
I am looking on Digikey for a driver that ticks all of the boxes. That is:
- Constant current of 195mA for a single strip or 390mA for two in parallel
A voltage range between 32.4 and 34.8V
A maximum power consumtion of 6.8W
Perhaps I would be better off wiring the two strips in series and looking for a constant voltage driver? But the data sheet says stick to constant current....
Can anyone help?