I've done some google and ended frustrated. I have HA installed on a 3B + and found something about pwmled which I'm guessing could could pwm a fan as well?
BN-Link sockets?
Any pointers greatly appreciated
Controlling AC Infinity Fan and BN-Link smart sockets?
the blower i've done it with a Mosfet and a ESP32 running ESPHOME :
viewtopic.php?f=35&t=5652
Sockets i love using Sonoffs S31 flashed with latest Tasmota
good luck
viewtopic.php?f=35&t=5652
Sockets i love using Sonoffs S31 flashed with latest Tasmota
good luck
You said:stud wrote: ↑Mon Jun 15, 2020 4:30 amthe blower i've done it with a Mosfet and a ESP32 running ESPHOME :
viewtopic.php?f=35&t=5652
Sockets i love using Sonoffs S31 flashed with latest Tasmota
good luck
BN-Links and Sonoff S31s running Tasmota fw for fan, heat and light control
Are you able to control your BN-Link sockets or just the S31s? I've got 12 of the BNs and hope there's a way.
all my fans ,120v heaters ,water heaters , dehumidifiers ,humidifiers , pumps,water solenoids , all 120volts ac devices i want to switch on/off , i use Sonoff S31 relays .
i also have baseboards heaters 240v ac , i'm using Sonoff R2 POW .
my LEDs im switch on/off and dimming with PWM ,i don't need a relay , but if i would need one ,i would use Sonoff once again .
all sonoffs can be flashed very easly with tasmota and tasmota is very easy to integrate into home assistant w/t MQTT .
plenty of tutorials on google .
now your BN-Link might be a Tuya , you have to search , i'm a Tasmota Fan so i stick to Tasmota compatible relays , and i love Sonoffs for my Green House
i also have baseboards heaters 240v ac , i'm using Sonoff R2 POW .
my LEDs im switch on/off and dimming with PWM ,i don't need a relay , but if i would need one ,i would use Sonoff once again .
all sonoffs can be flashed very easly with tasmota and tasmota is very easy to integrate into home assistant w/t MQTT .
plenty of tutorials on google .
now your BN-Link might be a Tuya , you have to search , i'm a Tasmota Fan so i stick to Tasmota compatible relays , and i love Sonoffs for my Green House
about your sockets : https://community.home-assistant.io/t/b ... e/105628/5
If this or similar works I should be ok.
https://cwiggs.com/post/2019-10-11-tasm ... nk-bnc-60/
The tuya word was key for the search. Thank you!
https://cwiggs.com/post/2019-10-11-tasm ... nk-bnc-60/
The tuya word was key for the search. Thank you!
I'm running Sonoff S31s and BNLink BNC60s as well. They're epic value. I flashed the S31s using the solder method but the BNlinks can be flashed OTA using the method linked above. I feel the Sonoffs are better quality -- just a feeling.
I use two SparkFun optoisolator breakout boards, but there are others. It takes the 10V supply provided by my fan (a Cloudline S4) and sends it back to the fan after applying the pwm signal from the pi.
I now control two fans and a meanwell driver, it's nifty!