Parallel Wiring with Wago Connectors
Just take one of the 5 ports and go to another 5 port wago.
Want to Support the Site?
Use this Amazon referral link and any purchase you make within 24 hrs will earn LEDgardener a commission at no cost to you!
Use this Amazon referral link and any purchase you make within 24 hrs will earn LEDgardener a commission at no cost to you!
-
- LED Enthusiast
- Reactions:
- Posts: 34
- Joined: Sun Nov 26, 2017 4:14 pm
I'm going to use these for my build my light. They just came in the mail today
CCG
CheersCCG
Yup. You need to make sure your wago-to-wago wire is thick enough to handle the current though, as there will be a lot of current on these runs in big systems. The wago-to-strip should be fine as 18 gauge (and you can't go bigger since the connector won't take it), but you may need 14 gauge or bigger to connect the wagos up to the driver and to one another, depending on the current level.
Want to Support the Site?
Use this Amazon referral link and any purchase you make within 24 hrs will earn LEDgardener a commission at no cost to you!
Use this Amazon referral link and any purchase you make within 24 hrs will earn LEDgardener a commission at no cost to you!