yep the 1 footers go quick.( 5000k only ones in stock atm ) the "two footers" are 560mm=22" if you only add a 1/2" heat sink further on each side(23" total) and use angle 3/4 x 3/4 as frame.... it should just squeeze in the tent.. my 5x5 is a hair bigger than 60"... most are slight bigger.. but there is always a few that are dead on or slightly smaller.
Need help for Bridgelux Gen. 2 BXEB-L0560Z 1′ LED Strip Build – 1’x1′
- Jolly Green Giant
- LED Wizard
- Reactions:
- Posts: 835
- Joined: Thu Jun 15, 2017 1:35 am
- Location: somewhere in NY
"again your math is spot on.... but I think your looking at gen 1 strip data sheets ( the 22.1v and 50C giving it away..... gen two 19.5v and 25C...I looked at the same data sheet a few times before figuring which was which)"
ahahaahhaha too much calculation and searches on the net..ok..everything is allright..i'm gonna recalculate what i need..now i have understand 2/3 of what i need to know..tomorrow i'll go to an electro shop that i saw yesterday for the little parts and i'll spit out my doubt..thanks again..
ahahaahhaha too much calculation and searches on the net..ok..everything is allright..i'm gonna recalculate what i need..now i have understand 2/3 of what i need to know..tomorrow i'll go to an electro shop that i saw yesterday for the little parts and i'll spit out my doubt..thanks again..
Yeah I like the HLG-60H-20 for this build.
Want to Support the Site?
Use this Amazon referral link and any purchase you make within 24 hrs will earn LEDgardener a commission at no cost to you!
Use this Amazon referral link and any purchase you make within 24 hrs will earn LEDgardener a commission at no cost to you!