Hlg 600h-48a
So Ive got the meanwell hlg 600h-48a and its got a third set of wires on the output side. Im assuming these are for a potentiometer. It has 3 wires red black and yellow. I thought only b drivers had this and its definitely an a with 2 built in potentiometers. What do I do with them?
-
- LED Enthusiast
- Reactions:
- Posts: 45
- Joined: Sun Jan 21, 2018 12:30 am
They are for remotely turning on/off the driver from an external input. Normally a voltage.
Seal them up with a heatshrink tail or throw a connector on them if not in use.
Seal them up with a heatshrink tail or throw a connector on them if not in use.