Hi everyone,
Noob here, tried searching the forum without much luck. I've ordered 3 qb 288 v2. I plan to run in a series with a hlg 320h c1750a. I did the math when I made my order. Looking at it now something seems off. Did I mess up?
Thanks,
3* qb288 driver question
-
- LED-Curious
- Reactions:
- Posts: 14
- Joined: Thu Apr 26, 2018 2:28 pm
The set up will probably max out at 270watts depends how much current the driver will allow, the A type drivers will normally do a little more than the specs suggest.
An HLG-320H-C2100A or B would be a better choice.
An HLG-320H-C2100A or B would be a better choice.
Hmmm, that 2100 will only do 152V; I don’t think it’ll be able to run 3 actually.
Want to Support the Site?
Use this Amazon referral link and any purchase you make within 24 hrs will earn LEDgardener a commission at no cost to you!
Use this Amazon referral link and any purchase you make within 24 hrs will earn LEDgardener a commission at no cost to you!
-
- LED Maniac
- Reactions:
- Posts: 423
- Joined: Wed Apr 04, 2018 12:00 am
- Location: Ohio, USA
According to hlg's website, the qb288 v2 pulls 48.96v @ 2100mA. Is there a reason that driver won't run 3? That's only 147v. Maybe you are thinking qb288 v1?
NothinYet is my nickname
It also says to add a tolerance of 1V for each board for matching. That being said, that’d still only be 150V so you guys are right - it should work.
Want to Support the Site?
Use this Amazon referral link and any purchase you make within 24 hrs will earn LEDgardener a commission at no cost to you!
Use this Amazon referral link and any purchase you make within 24 hrs will earn LEDgardener a commission at no cost to you!
-
- LED Maniac
- Reactions:
- Posts: 423
- Joined: Wed Apr 04, 2018 12:00 am
- Location: Ohio, USA
Hmm. I didn't see that. Nice
NothinYet is my nickname