I contacted rapidled about their cased potentiometer. I asked if they had a 33k ohm one or could do the 30k ohm with resistor wired in. This was their response:
resistance is variable on the cased pot so one cased pot will work for three drivers.
Just wanted to double check if this is ok because as far as i knew i needed a linear taper pot of a specific resistance
potentiometer question
- DaveJonesFan
- LED Enthusiast
- Reactions:
- Posts: 98
- Joined: Sun Dec 31, 2017 5:43 am
The Rapid LED one should also work fine. I've used some on 2 driver configs and they have a bit of dead spot at the end but otherwise seem fine.
I know I'm not right
But I'm not wrong, no, I'm not wrong
Girl, you hate it when I'm too high
But that's where I belong, where I belong
But I'm not wrong, no, I'm not wrong
Girl, you hate it when I'm too high
But that's where I belong, where I belong