QB304 Driver selection no help from hlg!
My question is I have six qb304 boards with heat sinks. But I want to run them in 3 separate series of 2. For Mobility. Hlg website recommends 240 h C 1050. But I want to run my boards between 125 and 135 watts each. Any help would be deeply appreciated my plants are waiting for the improved light source. Thank you in advance!
-
- LED-Curious
- Reactions:
- Posts: 8
- Joined: Tue Oct 30, 2018 1:54 am
I am running something veeeery similar to what you have and was worried about wiring in parallel. I have 3 QB288 V2 boards on one heat sink and another three the same way all wired in parallel using a 5 port wagos to help with the worry of thermal runaway. I also will put some fuses on it later but had to get the lights up and running before things got weird. So far all is good!
Go parallel without a worry.
Go parallel without a worry.
-
- LED-Curious
- Reactions:
- Posts: 8
- Joined: Tue Oct 30, 2018 1:54 am
PS: That was and is my FIRST build. Took 20mins
Thank you so much for all your input now I have to find out what size screws to use to mount my Quantum boards to the heat sinks. Hlg apparently forgot to put them in the box with the 6 kits I ordered. If I want to get them done in a timely fashion I'm going to have to buy a box of 50 screws. If anyone knows what size screws these are I'd appreciate some insight.
-
- LED-Curious
- Reactions:
- Posts: 8
- Joined: Tue Oct 30, 2018 1:54 am
M3 Screws
HLG says:
1x Slate 2 Predrilled 340mm Heatsink
M3 Screws to mount board included
HLG says:
1x Slate 2 Predrilled 340mm Heatsink
M3 Screws to mount board included